Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Assemble the cylinder head as necessary. Cylinder Head Assemble (LGX)
- Ensure the cylinder head locating pins (5) are securely mounted in the cylinder block deck face.
- Install a NEW right cylinder head gasket (4) using the deck face locating pins for retention.
- Cylinder Head Assembly - Install - Cylinder Head Installation - Right Side (LGX)
- Valve Lifter -Right Side Install - Valve Lifter Replacement - Right Side (LGX)
- Camshaft Carrier- Right Side - Install - Camshaft Carrier Installation - Right Side
- Camshaft-Right Side Install - Camshaft Installation - Right Side (LGX)
- Position wire harness and connect as necessary.
- Install ground wire and ground wire bolt. Tighten bolt to 15 N.m (11 lb ft).
- Fuel Pump Install - Fuel Pump Replacement (LGX)
- Warm Up Three-Way Catalytic Converter @ Bank 1 Install - Catalytic Converter Replacement - Right Side (LGX)
- Fuel Injection Fuel Rail Noise Shield - Install - Fuel Injection Fuel Rail Noise Shield Replacement
- Camshaft Timing Chain-Right Side - Install - Camshaft Timing Chain Assembly Replacement - Right Side (LGX)
CAUTION:
Refer to Fastener Caution .