Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Assemble the cylinder head as necessary. Refer to Cylinder Head Assemble (LF4) .
- Ensure the cylinder head locating pins are securely mounted in the cylinder block deck face.
- Cylinder Head Gasket - Install NEW
- Align the right cylinder head (2) with the deck face locating pins.
- Place the right cylinder head in position on the deck face.
- DO NOT allow oil on the cylinder head bolt bosses.
- DO NOT reuse the old cylinder head bolts.
- Install the NEW M11 cylinder head bolts (1).
- Tighten the M11 cylinder head bolts a first pass in sequence to 30 N.m (22 lb ft).
- Tighten the M11 cylinder head bolts a second pass in sequence an additional 150 degrees using the EN-45059 meter.
- Install the NEW M8 cylinder head bolt (2).
- Tighten the M8 cylinder head bolt a first pass to 15 N.m (11 lb ft).
- Tighten the M8 cylinder head bolt a second pass an additional 75 degrees using the EN-45059 meter.
- Radiator Outlet Pipe Bracket Bolt @ Cylinder Head Assembly - Install and tighten 22 N.m (16 lb ft)
- Turbocharger @ Bank 1 Install - Turbocharger Replacement (Bank 1) Turbocharger Replacement (Bank 2)
- Fuel Feed Intermediate Pipe Install - Fuel Feed Intermediate Pipe Replacement (LF4)
- Fuel Feed Front Pipe Install - Fuel Feed Front Pipe Replacement
- Secondary Timing Drive Chain @ Right Side Install - Secondary Camshaft Intermediate Drive Chain Replacement - Right Side (LF4)
CAUTION:
Refer to Fastener Caution .
NOTE: