LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Engine Mechanical - 3.6L (LF4 LGX) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal and Housing Replacement (LF4 (Manual Transmission)) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine. Refer to Engine Replacement (LF4 (Automatic Transmission)) Engine Replacement (LF4 (Manual Transmission)) .
  2. Remove the engine flywheel. Refer to Engine Flywheel Replacement .
  3. Remove the oil pan to crankshaft rear oil seal housing bolts . Refer to Oil Pan Replacement (LF4) .
    4. Fig 1: Crankshaft Rear Oil Seal & Housing Bolts
    GM2658930Courtesy of GENERAL MOTORS COMPANY
  4. Remove the crankshaft rear oil seal and housing bolts (1).
    5. Fig 2: Crankshaft Rear Oil Seal Housing Pry Points
    GM2658949Courtesy of GENERAL MOTORS COMPANY
  5. Use the pry points located at the edge of the crankshaft rear oil seal housing to separate the RTV sealant.
    6. Fig 3: Crankshaft Rear Oil Seal Housing
    GM2658951Courtesy of GENERAL MOTORS COMPANY
  6. Remove and discard the crankshaft rear oil seal and housing (1).
scientia non olet · About LEMON Manuals