Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the 6 mm (0.236 in) guides from the EN-46109 pin set into the 2 crankshaft rear oil seal housing corner bolt holes of the engine block
- Install the EN-47839 tool with the EN-42183 handle (1, 2) onto the rear of the crankshaft flange.
- Place a 3 mm (0.118 in) bead of RTV sealant (1) to the NEW crankshaft rear oil seal housing as shown (1). Refer to Adhesives, Fluids, Lubricants, and Sealers (LF4) , for recommended sealant.
- Install the crankshaft rear oil seal housing (1) to the engine block.
- Remove the EN-46109 pin set 6 mm (0.236 in) guides (1) from the engine block.
- Install the crankshaft rear oil seal housing bolts (1).
- Tighten the crankshaft rear oil seal housing bolts in sequence and tighten to 10 N.m (89 lb in).
- Remove the EN-47839 tool and EN-42183 handle (1, 2) from the crankshaft flange.
- Install the oil pan to crankshaft rear oil seal housing bolts . Refer to Oil Pan Replacement (LF4) .
- Install the flex plate. Refer to Automatic Transmission Flex Plate Replacement (LF4) .
NOTE:
DO NOT allow any engine oil on the area where the crankshaft rear oil seal housing is to be installed.
CAUTION:
Refer to Fastener Caution .