LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Controls And Fuel - 3.6L (LF4 LGX) - DTC P0121 LF4 To DTC P0685 LF4) >> Diagnostic Information and Procedures >> DTC P0171, P0172, P0174, or P0175: Fuel Trim System >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify no other DTCs are set.
    • If no other DTCs are set 
  3. Verify the MAP sensor pressure parameter is within the range specified for your altitude. Refer to Altitude Versus Barometric Pressure .
    • If not within the specified range 

      Refer to DTC P0106 .

    • If within the specified range 
  4. NOTE:

    Fuel vapor introduced into the intake manifold during evaporative emission system purge can temporarily cause fuel trim parameter readings to be outside the normal range.

  5. Engine running at the operating temperature, EVAP Purge Solenoid Valve Command 0%.
  6. Verify the appropriate Long Term Fuel Trim Bank 1 or 2 parameter is between -20% and +20%.
    • If greater than +20% 
    1. Ignition OFF.
    2. Verify the conditions listed below do not exist:
    • If less than -20% 
    1. Ignition OFF.
    2. Verify the conditions listed below do not exist:
    • If between -20% and +20% 
  7. All OK.