Removal Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clutch Pilot Bearing

Courtesy of GENERAL MOTORS COMPANY

Remove the transmission. Transmission Replacement (M3L)Transmission Replacement (MG9)
Remove the clutch assembly. Clutch Assembly Replacement (M3L Transmission) Clutch Assembly Replacement (MG9 Transmission)

NOTE:

When using the DT-43276 , always secure the DT-43276-1 tool body using a wrench. Do not allow the DT-43276-1 tool to rotate. Failing to do so causes damage to the DT-43276-1 tool body.

Remove the clutch bearing using the DT-43276 .
1. Install the DT-43276-1 into the clutch pilot bearing .
2. Using a wrench, secure the DT-43276-1 .
3. Insert the DT-43276-2 into the DT-43276-1 .
4. Rotate the DT-43276-2 clockwise into the DT-43276-1 until the clutch pilot bearing is completely removed from the crankshaft.
5. Rotate the DT-43276-2 counterclockwise to remove the DT-43276-2 from the DT-43276-1 .
6. Remove the DT-43276-1 from the tool body.