LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Manual Transmission - TREMEC 6-Speed (Mg9 M3L)) >> Repair Instructions - On Vehicle >> Transmission Control Lever Knob Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transmission Control Lever Boot
    GM4167934Courtesy of GENERAL MOTORS COMPANY
  1. Clean the stub shaft and fastener (2) threads prior to reinstalling the shift knob to remove residual threadlocker using a (recommended) tap and die set.
  2. Position the transmission control lever boot and knob assembly on the transmission control lever.
  3. Apply threadlocker to the shift knob fastener (2) and install the fastener. Adhesives, Fluids, Lubricants, and Sealers (MG9) Adhesives, Fluids, Lubricants, and Sealers (M3L) .
    4. CAUTION:

    Refer to Fastener Caution .

  4. Tighten the fastener to 7 N.m (62 lb in).
  5. Install the transmission control lever boot (1) to the console.
scientia non olet · About LEMON Manuals