LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Manual Transmission - TREMEC 6-Speed (Mg9 M3L)) >> Repair Instructions - On Vehicle >> Main Shaft Rear Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Propeller Shaft Nounting Components
    GM1236100Courtesy of GENERAL MOTORS COMPANY
  1. Place the transmission in neutral.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Base)Lifting and Jacking the Vehicle (V-Series)
  3. Remove the propeller shaft (6). Refer to Two-Piece Propeller Shaft Replacement (LTG, LGX, LCV)Two-Piece Propeller Shaft Replacement (LF4)
    4. Fig 2: View Of Flange Tool
    GM804354Courtesy of GENERAL MOTORS COMPANY
  4. Install the J 45012  holding fixture to the drive flange.
  5. While holding the J 45012  holding fixture , remove the flange nut using the J 29873  injector nozzle socket.
  6. Remove the J 45012  holding fixture.
    7. Fig 3: Removing Drive Flange Thrust Washer
    GM1430041Courtesy of GENERAL MOTORS COMPANY
  7. Remove the drive flange thrust washer.
  8. Remove the drive flange using the J 45019  flange and pinion gauge remover.
    9. Fig 4: Removing Transmission Case Extension Seal
    GM794669Courtesy of GENERAL MOTORS COMPANY
  9. Use the J 6125-1B  slide hammer and J 23129  universal seal remover to remove the transmission case extension seal (1).
scientia non olet · About LEMON Manuals