LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Manual Transmission - TREMEC 6-Speed (Mg9 M3L)) >> Repair Instructions - On Vehicle >> Backup Lamp Switch Replacement (M3L) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Vehicle Speed Sensor & Bolt
    GM2838572Courtesy of GENERAL MOTORS COMPANY
  1. Apply sealant to the threads of the backup lamp switch. Refer to Adhesives, Fluids, Lubricants, and Sealers (M3L)  for the recommended sealant material.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the backup lamp switch (2) and tighten the switch to 27 N.m (20 lb ft).
    3. Fig 2: Vehicle Speed Sensor Electrical Connector
    GM2838600Courtesy of GENERAL MOTORS COMPANY
  3. Connect the backup lamp switch electrical connector (1).
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals