Transmission Case
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the 1st/2nd and the 3rd/4th shift shaft bearing. Use the J 36190 driver handle (1) and the J 44384 bearing installer (2).
- Install the mainshaft bearing race (3), using the J 8092 driver handle (1) and the J 39435 installer (2).
- Install the countershaft bearing race (3), using the J 8092 driver handle (1) and the J 39435 installer (2).
- Install the dowel pins (1).
- Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the threads of the transmission case fill plug (1), the temperature sensor (3) and the cooler line return fitting (2).
- Install the transmission case cooler line return fitting (1) and tighten to 18 N.m (13 lb ft).
- Install the transmission case fill plug (2) and tighten to 27 N.m (20 lb ft).
- Install the coolant temperature sensor (3) and tighten to 39 N.m (29 lb ft).
- Install the guide plate (2) and the guide plate bolts (1) and tighten to 22 N.m (16 lb ft)
NOTE:
The end of the bearing that has numbers stamped on it must face the J 44384 bearing installer , so that the numbers are visible when the bearing is installed.
NOTE:
Bearings and Races are replaced as sets.
Fig 5: Applying Sealant To Threads Of Transmission Case Fill Plug, Temperature Sensor & Cooler Line Return Fitting
CAUTION:
The H-pattern on the guide plate must face the extension housing. If the guide plate is installed incorrectly, then damage will occur.