Reverse Speed Gear Installation

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Reverse Gear Components

Courtesy of GENERAL MOTORS COMPANY

Install the following parts in order:
1. The reverse gear blocking ring assembly (5), including the following components:
  - Reverse gear inner ring (6)
  - Reverse gear outer ring (7)
  - Reverse gear blocking ring (8)
2. The caged needle bearing (4)
3. The reverse speed gear (3)
4. The thrust washer (2)
5. The retainer ring (1)

Fig 2: Identifying Rear Bearing Retainer Ring, Spacers & Mainshaft Rear Roller Bearing

Courtesy of GENERAL MOTORS COMPANY

Install the following parts in order:
1. The spacer (3)
2. The roller bearing (2)
3. The spacer (3)
4. The roller bearing retainer ring (1)

Fig 3: Identifying Snap Ring, Speed Sensor Rotor & Locking Ball

Courtesy of GENERAL MOTORS COMPANY

Install the following parts in order:
- The locking ball (3)
- The speed sensor rotor (2)
- The snap ring (1)

Fig 4: Identifying Shift Guide Rollpin, Shift Shaft Extension & Extension Housing Main Shaft Bearing Race

Courtesy of GENERAL MOTORS COMPANY

Install the extension housing main shaft bearing race (3).
Install the shift shaft extension (2).
Install NEW shift guide roll pin (1).

Fig 5: Identifying Plug, Spring & Shift Detent Roller

Courtesy of GENERAL MOTORS COMPANY

Lift up on the shift shaft extension while installing the shift detent roller (3), spring (2) and plug (1). Tighten the shift shaft detent plug to 50 N.m (37 lb ft).