Front Side Door Window Regulator Replacement (Sedan)

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Side Door Window Regulator (Sedan)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the front side door trim. Refer to Front Side Door Trim Replacement (Sedan) .
1	Front Side Door Window Regulator Guide Nuts (Qty: 2) WARNING: Refer to Glass and Sheet Metal Handling Warning . WARNING: Disconnect the power window switch when working inside the door. When operated, the Express Up/Down Feature allows the door window to move very quickly, without stopping, which could cause personal injury. CAUTION: Refer to Fastener Caution . Procedure Remove the water deflector. Position the window to access the window regulator guide nuts. Refer to Front Side Door Window Replacement (Sedan) . Place the window in the full up position and tape in place. NOTE: Leave the two upper bolts in the window regulator for alignment when installing. It maybe necessary to transfer the bolts if replacing the window regulator. Tighten 10 N.m (89 lb in)
2	Front Side Door Window Regulator Bolts (Qty: 5) Procedure Disconnect the front side door window regulator electrical connector. Tighten 10 N.m (89 lb in)
3	Front Side Door Window Regulator Procedure Transfer the window regulator motor. Refer to Front Side Door Window Regulator Motor Replacement . NOTE: Inspect the door window for proper operation before installing the door trim.