Front Side Door Window Regulator Replacement (Coupe)

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Side Door Window Regulator (Coupe)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to Glass and Sheet Metal Handling Warning . WARNING: Disconnect the power window switch when working inside the door. When operated, the Express Up/Down Feature allows the door window to move very quickly, without stopping, which could cause personal injury. Preliminary Procedures Remove the front side door window. Refer to Front Side Door Window Replacement (Coupe) . Remove the water deflector. Disconnect the electrical connector.
1	Front Side Door Window Regulator Access Hole Plug (Qty: 4) NOTE: The lower access plugs are located in the bottom of the door.
2	Front Side Door Window Regulator Lower Nut (Qty: 2) CAUTION: Refer to Fastener Caution . NOTE: The bottoming mounting of the regulator to door is the in and out adjustment for the top of the glass. Before removing the nuts, use a grease pencil to mark the location of the nuts for installation. This will be the starting point for the top of the glass adjustment. Tighten 11.5 N.m (8.5 lb ft)
3	Front Side Door Window Regulator Upper Nut (Qty: 3) Tighten 11.5 N.m (8.5 lb ft)
4	Front Side Door Window Regulator Procedures Transfer all necessary components. Program the window regulator motor after installing in the vehicle. Refer to Window Motor Programming - Express Function . NOTE: Check the top glass fit after the rim panel is installed and adjust as necessary using the lower regulator nuts.