LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION:

    Use care when removing or installing the stabilizer shaft as coating can be removed by contact with tools or other vehicle components. Corrosion will occur and early stabilizer shaft failure will be the result.

    Fig 1: ID Label
    GM4256711Courtesy of GENERAL MOTORS COMPANY
  1. Prior to installation verify that the ID label (1) is on the right hand side of the vehicle.
    2. Fig 2: Rear Stabilizer Shaft
    GM4256709Courtesy of GENERAL MOTORS COMPANY
  2. Rear Stabilizer Shaft - Install
  3. Install the stabilizer shaft with the vehicle at curb height.
    4. CAUTION:

    Refer to Fastener Caution .

    Fig 3: Rear Stabilizer Shaft Insulator Clamp Bolt
    GM4256705Courtesy of GENERAL MOTORS COMPANY
  4. Rear Stabilizer Shaft Insulator Clamp Bolt - Install and tighten 58 N.m (43 lb ft)
    5. Fig 4: Rear Stabilizer Shaft Link
    GM4253604Courtesy of GENERAL MOTORS COMPANY
  5. Rear Stabilizer Shaft Link @ Left Side - Install - Stabilizer Shaft Link Replacement 
    6. Fig 5: Rear Stabilizer Shaft Link
    GM4253588Courtesy of GENERAL MOTORS COMPANY
  6. Rear Stabilizer Shaft Link @ Right Side - Install - Stabilizer Shaft Link Replacement 
  7. Exhaust Muffler - Install - Exhaust Muffler Replacement (LCV)Exhaust Muffler Replacement (LF4)Exhaust Muffler Replacement (LTG)
scientia non olet · About LEMON Manuals