Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Rear Suspension Bracket - (3) Install
- Install two NEW rear suspension front bracket bolts (1) and tighten to 58 N.m (43 lb ft)
- Rear Suspension Cradle Rear Mounting Bolt - Install a NEW bolt. Rear Suspension Cradle Replacement
- Reposition the hoist lift pad (2) back underneath the vehicle.
- Using the adjustable jack stand (1) and the block of wood, slowly lower the vehicle back on the hoist pad (2).
- Remove the adjustable jack stand (2) and the block of wood (1) from underneath the vehicle.
- Underbody Rear Air Deflector - Install - Underbody Rear Air Deflector Replacement - Left Side , or Underbody Rear Air Deflector Replacement - Right Side
- Remove the jack stand (1) supporting the rear drive axle.
- Lower the vehicle.
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
CAUTION:
Refer to Fastener Caution .