Installation Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Steering Knuckle

Courtesy of GENERAL MOTORS COMPANY

Position the steering knuckle (1) on the vehicle.

Fig 2: Strut Assembly to Steering Knuckle

Courtesy of GENERAL MOTORS COMPANY

Strut Assembly @ Steering Knuckle - Install Strut Assembly Removal and Installation (FE2 or FE3 With F55) Strut Assembly Removal and Installation (FE2 Without F55) Strut Assembly Removal and Installation (FE4 With F55)

Fig 3: Front Lower Control Rear Link to Steering Knuckle

Courtesy of GENERAL MOTORS COMPANY

Front Lower Control Rear Link @ Steering Knuckle - Install Front Lower Control Rear Link Replacement (Non V-Series)

Fig 4: Front Lower Control Front Link to Steering Knuckle

Courtesy of GENERAL MOTORS COMPANY

Front Lower Control Front Link @ Steering Knuckle - Install Front Lower Control Front Link Replacement (Non V-Series With RWD)

Fig 5: Steering Linkage Outer Tie Rod to Steering Knuckle

Courtesy of GENERAL MOTORS COMPANY

Steering Linkage Outer Tie Rod @ Steering Knuckle - Install Steering Linkage Outer Tie Rod Replacement (Non V-Series)

Fig 6: Front Wheel Bearing and Hub Assembly

Courtesy of GENERAL MOTORS COMPANY

Front Wheel Bearing and Hub Assembly - Install Front Wheel Bearing and Hub Replacement (Non V-Series With RWD)

Fig 7: Front Brake Shield

Courtesy of GENERAL MOTORS COMPANY

Front Brake Shield - Install Front Brake Shield Replacement (JE5, J55)Front Brake Shield Replacement (J6G)
Measure and adjust the wheel alignment. Wheel Alignment Measurement