Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Front Stabilizer Shaft - Install
- Using a swivel socket, install the right side front stabilizer shaft insulator clamp (2) and nuts (1) and tighten the nuts to 22 N.m (16 lb ft).
- Using a swivel socket, install the left side front stabilizer shaft insulator clamp (2) and nuts (1) and tighten the nuts to 22 N.m (16 lb ft).
- Engine Mount Vacuum Tank Replacement - Install
- Front Stabilizer Shaft Link @ Front Stabilizer Shaft - Install - Stabilizer Shaft Link Replacement (V-Series)
- Front Brake Rotor Cooling Duct Deflector Replacement - Install
- Front Cradle Shear Plate Replacement (V Series) - Install
- Front Compartment Air Deflector Replacement (V Series) - Install
- Install the front tire and wheel assemblies. Tire and Wheel Removal and Installation (V-Series October 4th 2015 and Earlier)Tire and Wheel Removal and Installation (V-Series October 5th 2015 and Later)
CAUTION:
Refer to Fastener Caution .
CAUTION:
Use caution when removing components surrounding the Steering Gear Boots. Avoid tool contact with the steering gear boot and clamps. Damage to the steering gear boot may lead to dirt and water contamination in the steering gear rack and components requiring a preventable replacement of the Steering Gear and its Components.
CAUTION:
Use caution when removing components surrounding the Steering Gear Boots. Avoid tool contact with the steering gear boot and clamps. Damage to the steering gear boot may lead to dirt and water contamination in the steering gear rack and components requiring a preventable replacement of the Steering Gear and its Components.