Removal Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the front tire and wheel assemblies. Tire and Wheel Removal and Installation (Non V-Series)
- Engine Compartment Lower Noise Shield Replacement - Remove
- Front Air Deflector Replacement - Remove
- Front Stabilizer Shaft Link@Front Stabilizer Shaft - Separate - Stabilizer Shaft Link Replacement (Non V-Series)
- Disconnect the steering gear electrical connectors.
- { If equipped } Engine Mount Vacuum Tank Replacement - Remove
- Using a swivel socket, remove the left side front stabilizer shaft insulator clamp nuts (1) and clamp (2).
- Using a swivel socket, remove the right side front stabilizer shaft insulator clamp nuts (1) and clamp (2).
- Front Stabilizer Shaft - Remove
CAUTION:
Use caution when removing components surrounding the Steering Gear Boots. Avoid tool contact with the steering gear boot and clamps. Damage to the steering gear boot may lead to dirt and water contamination in the steering gear rack and components requiring a preventable replacement of the Steering Gear and its Components.
NOTE:
On rear wheel drive vehicles, the front stabilizer shaft insulators are NOT serviceable. Do NOT transfer the insulators.