Installation Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Steering gear

Courtesy of GENERAL MOTORS COMPANY

Position the steering gear (1) on the vehicle.

Fig 2: Steering Gear Bolt

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

Steering Gear Bolt - Install
Install NEW bolts.

CAUTION:

Refer to Fastener Caution .

Steering Gear Nut - Install and tighten
Tighten
1. First Pass: 58 N.m (43 lb ft)
2. Final Pass: (90-105 degrees)

Fig 3: Steering Gear Electrical Connectors

Courtesy of GENERAL MOTORS COMPANY

Connect the steering gear electrical connectors (1).

Fig 4: Intermediate Steering Shaft And Steering Gear

Courtesy of GENERAL MOTORS COMPANY

Intermediate Steering Shaft @ Steering Gear - Install - Intermediate Steering Shaft Replacement (RWD)Intermediate Steering Shaft Replacement (AWD)

Fig 5: Front Cradle Shear Plate

Courtesy of GENERAL MOTORS COMPANY

Front Cradle Shear Plate - Install - Front Cradle Shear Plate Replacement (V Series)

Fig 6: Steering Linkage Outer Tie Rod And Steering Knuckle

Courtesy of GENERAL MOTORS COMPANY

Steering Linkage Outer Tie Rod @ Steering Knuckle - Install - Steering Linkage Outer Tie Rod Replacement (V-Series)
Program the power steering control module. Control Module References
Measure and adjust the front toe. Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment