Removal Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Battery Negative Cable - Disconnect Battery Negative Cable Disconnection and Connection .
- Front Compartment Front Sight Shield - Remove Front Compartment Front Sight Shield Replacement (Sedan)Front Compartment Front Sight Shield Replacement (Coupe)Front Compartment Front Sight Shield Replacement (ATS-V) .
- Release the tabs on each side of the pre fuse block cover (1) and pull upward to remove.
- Lift the tab on the front compartment fuse block housing cover (1) upward and twist the cover 90 degrees to disengage the cover from the hinge.
- Battery Positive Cable Junction Block Lead Nut (1) - Remove
- Battery Positive Cable Junction Block Nut (2) - Remove
- Accessory Power Fuse Block Front Wiring Harness Nut (3) - Remove
- Engine Wiring Harness Terminal and Nut (1) - Remove
- Forward Lamp Wiring Harness Terminal and Nut (2) - Remove
- Fuse Battery Distribution Unit Engine Compartment Block Nut (1) - Remove
- Fuse Battery Distribution Unit Engine Compartment Block (1) - Remove
- Release the 4 retainer tabs using a suitable hook-like tool to release the locking levers to allow the locking levers to be rotated to the full up position on the front compartment fuse block housing (1).
- Remove the front compartment fuse block housing (1) by lifting on the locking levers, then with a slight shaking motion on the locking levers remove the front compartment fuse block housing from the fuse block housing base.