Water Pump Removal (LCV)
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the thermal bypass pipe (2), bolts (1), and gasket (3) from the water pump assembly. Discard the gasket. Disconnect the pipe from the water outlet assembly.
- Remove the retaining clip (5) and engine coolant temperature sensor (2).
- Remove the water outlet assembly (1), bolts (4), and gasket seal (3). Discard the gasket.
- Remove the thermostat assembly (2), bolts (3), and gasket seal (4). Discard the gasket.
- Remove the water pump assembly (5), bolts (1), and seal (6). Discard the seal.
NOTE:
The water outlet assembly may vary by model.