Camshaft Cover Removal (LCV)

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: PCV Hose Assembly

Courtesy of GENERAL MOTORS COMPANY

Remove the PCV hose assembly (1) at the quick-connect fittings.

Fig 2: Engine Coolant Air Bleed Pipe

Courtesy of GENERAL MOTORS COMPANY

Remove the engine coolant air bleed pipe (2), bolt (1), and O-ring (3). Inspect O-rings and discard if necessary.

Fig 3: Oil Level Indicator

Courtesy of GENERAL MOTORS COMPANY

Remove the oil level indicator (3). Inspect and replace the oil indicator O-ring seals (4), if necessary.

NOTE:

The heat shield may vary by model.

Remove the camshaft cover heat shield (2) and bolts (1).

Fig 4: Rear Lift Bracket And Bolts

Courtesy of GENERAL MOTORS COMPANY

Remove the rear lift bracket (1) and bolts (2).

Fig 5: Front Lift Bracket

Courtesy of GENERAL MOTORS COMPANY

Remove the front lift bracket (2) and bolts (1).

Fig 6: Ignition Coils And Bolts

Courtesy of GENERAL MOTORS COMPANY

Remove the ignition coils (2) and bolts (1).

Fig 7: Camshaft Position Actuator Control Solenoid Valves

Courtesy of GENERAL MOTORS COMPANY

Remove the camshaft position actuator control solenoid valves (2) and bolts (1).

Fig 8: Vacuum Assembly And Bolts

Courtesy of GENERAL MOTORS COMPANY

Remove the vacuum assembly (2) and bolts (1).
Remove the vacuum assembly gasket (3) and discard.

Fig 9: Camshaft Cover Assembly

Courtesy of GENERAL MOTORS COMPANY

Remove the bolts (1), bolt (4), washer (3), and camshaft cover assembly (2).
Remove and discard the camshaft cover gasket (5).