Removal Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Refer to Brake Dust Warning .
NOTE:
Always replace disc brake pads in axle sets.
- Inspect the fluid level in the brake master cylinder reservoir.
- If the brake fluid level is midway between the maximum-full point and the minimum allowable level, no brake fluid needs to be removed before proceeding.
- If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove brake fluid to the midway point before proceeding.
- Raise and support the vehicle. Lifting and Jacking the Vehicle (Base)Lifting and Jacking the Vehicle (V-Series)
- Tire and Wheel Removal and Installation (Non V-Series)Tire and Wheel Removal and Installation (V-Series October 4th 2015 and Earlier)Tire and Wheel Removal and Installation (V-Series October 5th 2015 and Later) - Remove
- Brake Caliper Guide Pin Bolt - Remove
- Brake Caliper Guide Pin - Remove
- Brake Pad Guide Pin - Remove
- Disc Brake Pad Spring - Remove
- Inner Disc Brake Pad - Remove
- Outer Disc Brake Pad - Remove
- Using a spreader tool, carefully compress the brake caliper pistons fully into the brake caliper bores.