LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Disc Brake System) >> Repair Instructions >> Front Brake Caliper Hardware Replacement (J6G) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Brake Dust Warning .

NOTE:

Always replace disc brake pads in axle sets.

  1. Raise and support the vehicle. Lifting and Jacking the Vehicle (Base)Lifting and Jacking the Vehicle (V-Series)
  2. Tire and Wheel Removal and Installation (Non V-Series)Tire and Wheel Removal and Installation (V-Series October 4th 2015 and Earlier)Tire and Wheel Removal and Installation (V-Series October 5th 2015 and Later) - Remove
    3. Fig 1: Brake Caliper Guide Pin Bolt
    GM4004089Courtesy of GENERAL MOTORS COMPANY
  3. Brake Caliper Guide Pin Bolt - Remove
    4. Fig 2: Brake Caliper Guide Pin
    GM4004090Courtesy of GENERAL MOTORS COMPANY
  4. Brake Caliper Guide Pin - Remove
    5. Fig 3: Brake Pad Guide Pin
    GM4004092Courtesy of GENERAL MOTORS COMPANY
  5. Brake Pad Guide Pin - Remove
    6. Fig 4: Disc Brake Pad Spring
    GM4004095Courtesy of GENERAL MOTORS COMPANY
  6. Disc Brake Pad Spring - Remove
scientia non olet · About LEMON Manuals