Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate the master cylinder reservoir seals with GM approved brake fluid from a clean, sealed, brake fluid container.
- Install the 2 master cylinder reservoir seals (1).
- Firmly and squarely press the master cylinder reservoir (1) into the master cylinder.
- Install the master cylinder reservoir bolt (1) and tighten to 8 (71 lb in).
- If equipped, connect the clutch master cylinder feed hose.
- Install the brake fluid level indicator switch. Brake Fluid Level Indicator Switch Replacement
- Plenum Front Panel - Install — Plenum Front Panel Replacement
- Fill the master cylinder reservoir. Master Cylinder Reservoir Filling
NOTE:
Ensure the reservoir seals are fully seated in the master cylinder.
NOTE:
Ensure the master cylinder reservoir is fully seated in the master cylinder.
CAUTION:
Refer to Fastener Caution .