LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Engine Cooling System) >> Repair Instructions >> Engine Coolant Thermostat Housing Replacement (LF4) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Coolant Thermostat Housing
    GM4277398Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Install a NEW engine coolant thermostat gasket.

  1. Engine Coolant Thermostat Housing Gasket - Install
  2. Engine Coolant Thermostat Housing - Install
  3. CAUTION:

    Refer to Fastener Caution .

  4. Engine Coolant Thermostat Housing Bolt - Install and tighten 10 N.m (89 lb in)
  5. Fig 2: Radiator Outlet Pipe And Bracket
    GM4045035Courtesy of GENERAL MOTORS COMPANY
  6. Radiator Outlet Pipe - Install - Radiator Outlet Pipe Replacement (LF4) 
  7. Fig 3: Fuel Feed Pipe
    GM4020004Courtesy of GENERAL MOTORS COMPANY
  8. Fuel Feed Pipe @ Engine Connect - Fuel Feed Pipe Replacement (LF4 at Engine)
  9. Fig 4: Evaporative Emission Canister Purge Tube Replacement (LF4)
    GM4016889Courtesy of GENERAL MOTORS COMPANY
  10. Evaporative Emission Canister Purge Tube @ Evaporative Emission Canister Purge Pipe Connect - Evaporative Emission Canister Purge Tube Replacement (LF4)
  11. Fig 5: Engine Coolant Temperature Sensor Electrical Connector
    GM4277316Courtesy of GENERAL MOTORS COMPANY
  12. Connect the engine electrical wiring harness (2) to the back of the engine.
  13. Engine Coolant Temperature Sensor Electrical Connector - Connect
  14. Fig 6: Heater Outlet Hose At Engine Coolant Thermostat Housing
    GM4276897Courtesy of GENERAL MOTORS COMPANY
  15. Heater Outlet Hose @ Engine Coolant Thermostat Housing Connect - Heater Outlet Hose Replacement (LF4)
  16. Fig 7: Heater Inlet Hose At Engine Coolant Thermostat Housing
    GM4276867Courtesy of GENERAL MOTORS COMPANY
  17. Heater Inlet Hose @ Engine Coolant Thermostat Housing Connect - Heater Inlet Hose Replacement (LF4)
  18. Fig 8: Hood Strut
    GM2807046Courtesy of GENERAL MOTORS COMPANY
  19. Hood Strut-Right Side - Install - Hood Strut ReplacementHood Strut Replacement (ATS-V)
  20. Fig 9: Fuel Pipe Shield
    GM4044075Courtesy of GENERAL MOTORS COMPANY
  21. Fuel Pipe Shield - Install - Fuel Pipe Shield Replacement (LF4)
  22. Fig 10: Intake Manifold Cover
    GM4044965Courtesy of GENERAL MOTORS COMPANY
  23. Intake Manifold Cover - Install - Intake Manifold Cover Replacement (LF4)
  24. Fill the cooling system. Cooling System Draining and Filling (Static) Cooling System Draining and Filling (GE 47716) 
  25. Start the engine and check for leaks.