LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Automatic Transmission Cooling System) >> Repair Instructions >> Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LCV Without V03) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Front Compartment Front Sight Shield Replacement (Sedan)Front Compartment Front Sight Shield Replacement (Coupe)Front Compartment Front Sight Shield Replacement (ATS-V) Remove
  2. Air Cleaner Assembly Replacement (LCV) Remove
    3. Fig 1: Transmission Fluid Cooler Inlet and Outlet Pipe And Retaining Clip
    GM4056749Courtesy of GENERAL MOTORS COMPANY
  3. Transmission Fluid Cooler Inlet and Outlet Pipe Retaining Clip at Radiator Remove - Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection 
    4. NOTE:

    Cover or plug all open transmission fluid cooler pipe connection points to help avoid any accidental contamination.

  4. Transmission Fluid Cooler Inlet and Outlet Pipe at Radiator Remove
  5. Front Wheelhouse Liner Replacement (Non V-Series)Front Wheelhouse Liner Replacement (V-Series) Remove -Left Side
  6. Front Air Deflector Replacement Remove
  7. Engine Compartment Lower Noise Shield Replacement Remove
    8. Fig 2: Transmission Fluid Cooler Inlet and Outlet Pipe Retaining Clip
    GM4056754Courtesy of GENERAL MOTORS COMPANY
  8. Transmission Fluid Cooler Inlet and Outlet Pipe Retaining Clip at Radiator Remove - Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection 
    9. NOTE:

    Cover or plug all open transmission fluid cooler pipe connection points to help avoid any accidental contamination.

  9. Transmission Fluid Cooler Inlet and Outlet Pipe at Radiator Remove
    10. Fig 3: Transmission Fluid Cooler Inlet And Outlet Pipe Clip Bolts At Engine Oil Pan
    GM4056758Courtesy of GENERAL MOTORS COMPANY
  10. Remove the transmission fluid cooler inlet and outlet pipe clip bolts (1) from the engine oil pan.
    11. Fig 4: Transmission Fluid Cooler Inlet And Outlet Pipe
    GM4056760Courtesy of GENERAL MOTORS COMPANY
  11. Disconnect the oxygen sensor connector (1) and set aside the oxygen sensor harness.
  12. Remove the transmission fluid cooler inlet and outlet pipe bolt (2) from the transmission.
    13. NOTE:

    Cover or plug all open transmission fluid cooler pipe connection points to help avoid any accidental contamination.

  13. Remove the transmission fluid cooler inlet and outlet pipe (3) from the transmission.
    14. Fig 5: Transmission Fluid Cooler Inlet And Outlet Pipe Fitting Seal
    GM4062912Courtesy of GENERAL MOTORS COMPANY
  14. Remove the transmission fluid cooler inlet and outlet pipe fitting seal (1).

    DISCARD the seal.

    15. Fig 6: Transmission Fluid Cooler Inlet And Outlet Pipe
    GM4056766Courtesy of GENERAL MOTORS COMPANY
  15. Remove the transmission fluid cooler inlet and outlet pipe (1) from the vehicle.
  16. Transfer components as necessary.
scientia non olet · About LEMON Manuals