Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Engine Coolant Temperature Sensor Seal -Install a NEW seal.
- Engine Coolant Temperature Sensor -Install
- Engine Coolant Temperature Sensor Retainer -Install
- Engine Coolant Temperature Sensor Fastener -Install and tighten 10 N.m (89 lb in)
- Engine Coolant Temperature Sensor Electrical Connector -Connect
- Connect the Fuel Feed Pipe - Fuel Tank to Engine to the Fuel Feed Pipe - at Engine. Fuel Feed Pipe Replacement (Fuel Tank To Engine LF4) Fuel Feed Pipe Replacement (LF4 at Engine)
- Engine Rear Noise Shield Replacement (LF4) -Install
- Plenum Front Panel Replacement -Install
- Cooling System Draining and Filling (Static)Cooling System Draining and Filling (GE 47716) -Fill the cooling system.
CAUTION:
Refer to Fastener Caution .