LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Engine Controls And Fuel - 3.6L (LF4 LGX) - Repair Instructions) >> Repair Instructions >> Crankshaft Position Sensor Replacement (LF4) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Front Cradle Shear Plate Replacement (V Series) -Remove
    2. Fig 1: Crankshaft Position Sensor Shield
    GM4053775Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The crankshaft position sensor shield (2) can be repositioned while allowing it to remain attached to the engine wiring harness retainer.

  2. Remove the crankshaft position sensor shield fasteners (1) then reposition the shield (2).
    3. Fig 2: Crankshaft Position Sensor Electrical Connector
    GM4053781Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the crankshaft position sensor electrical connector (1).
  4. Remove the crankshaft position sensor fastener (2).
  5. Remove the crankshaft position sensor (3).
scientia non olet · About LEMON Manuals