Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Camshaft Position Sensor -Install
- Camshaft Position Sensor Bolt -Install and tighten 10 N.m (89 lb in).
- Camshaft Position Sensor Electrical Connector @ Camshaft Position Sensor -Connect
- Intake Manifold Cover Replacement (LGX) -Install
NOTE:
Always install the camshaft position sensor O-ring (3) supplied with the NEW camshaft position sensor. If reinstalling the sensor, inspect the camshaft position sensor O-ring (3) and replace as necessary. Lubricate the camshaft position sensor O-ring (3) with clean engine oil prior to installing the camshaft position sensor.
CAUTION:
Refer to Fastener Caution .