LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Transfer Case - BW 4474) >> Diagnostic Information and Procedures >> DTC C0569: System Configuration Error Calibration Not Learned >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, engine ON. Let engine run for at least 1 minute.
  2. Ignition OFF for at least 30 seconds to allow for the complete shutdown of the K69 Transfer Case Control Module.
  3. Ignition ON, engine OFF.
  4. Verify that no other transfer case DTC's are set.
    • If any other transfer case DTC's are set 

      diagnose them first.

    • If no other transfer case DTC's are set 
  5. Verify that DTC C0569 is not set.
    • If DTC C0569 is not set 
  6. All OK.
scientia non olet · About LEMON Manuals