Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the transmission support (3).
- Install the transmission support bolts (2) and tighten to 60 N.m (44 lb ft).
- Install the transmission travel mount bolt (1) and tighten to 100 N.m (74 lb ft).
- Remove the support from under the transmission.
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .
NOTE:
The engine mounts must NOT bend or deflect from the vertical position, damage to the mount will occur.