Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Position the rear suspension support mount (1) in the rear suspension support.
- Position the rear suspension support mount (1) in the rear suspension support.
- Using the DT-50806 kit (1), (2), and J-45725-2 installer (3), install the rear suspension support bushings.
- With the aid of an assistant, position the rear support onto the transmission jack and firmly secure the support to the jack with straps.
- Install the rear suspension cradle. Refer to Rear Suspension Cradle Replacement .
- Install the tires and wheels. Refer to Tire and Wheel Removal and Installation (Non V-Series)Tire and Wheel Removal and Installation (V-Series October 4th 2015 and Earlier)Tire and Wheel Removal and Installation (V-Series October 5th 2015 and Later) .
- Remove the support and lower the vehicle.
- Check the rear alignment. Refer to Wheel Alignment Measurement .
NOTE:
For the front support mounts, ensure the flat side is in the correct position facing the passenger side of the vehicle before installing it.
NOTE:
For the rear support mounts, ensure the cut-out side is in the correct position facing the rear of the vehicle before installing it.
NOTE:
Apply a small amount of silicone grease on the support mount prior to installing.