Oil Pump Assemble
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Install Vacuum Pump Seal a NEW seal. |
| 2 | Dowel Pin
NOTE:
This is press fit and not serviceable. |
| 3 | Install Oil Pump Housing Passage Seal a NEW seal. |
| 4 | Install Oil Pump Housing Passage Seal a NEW seal. |
| 5 | Oil Pump Sprocket |
| 6 | Install Oil Pump Drive Bolt a NEW bolt. Do NOT reuse the old bolt.
CAUTION:
Refer to Fastener Caution . Tighten First Pass : 15 N.m (11 lb ft) Final Pass: 110 degrees |
| 7 | Oil Pump Suction Pipe Gasket»Install a NEW gasket. |
| 8 | Oil Pump Suction Pipe |
| 9 | Oil Pump Suction Pipe Bolt Tighten 10 N.m (89 lb in) |
| 10 | Oil Pump Flow Control Valve |
| 11 | Oil Pump Flow Control Valve Boltwith Insulator Tighten 5 N.m (44 lb in) |