Engine Block - Right - Rear
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
Engine Block - Right - Rear
| Callout | Component Name |
|---|---|
| 1 | Cylinder Head Locating Pin (Qty: 2) |
| 2 | Engine Block Core Hole Plug Procedure Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant Tighten 40 N.m (30 lb ft) |
| 3 | Crankshaft Position Sensor |
| 4 | Crankshaft Position Sensor Bolt Tighten 10 N.m (89 lb in) |
| 5 | Knock Sensor |
| 6 | Knock Sensor Bolt Tighten 25 N.m (18 lb ft) |
| 7 | Knock Sensor Heat Shield Bolt (Qty: 2) Tighten 10 N.m (89 lb in) |
| 8 | Knock Sensor Heat Shield |
| 9 | Engine Block Oil Gallery Plug M16 Tighten 40 N.m (30 lb ft) |
| 10 | Engine Coolant Temperature Sensor Tighten 9 N.m (80 lb in) |
| 11 | Crankshaft Rear Oil Seal Housing Locating Pin (Qty: 2) |
| 12 | Engine Block Oil Gallery Plug (Qty: 2) Tighten 40 N.m (30 lb ft) |