Ignition Coil, Spark Plug, Camshaft Cover, and Seal Installation
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS COMPANY Ignition Coil, Spark Plug, Camshaft Cover, and Seal Installation
| Callout |
Component Name |
| 1 |
Sealant Procedure
- Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
- Place a bead 8 mm (0.3150 in) in diameter by 4 mm (0.1575 in) in height of RTV sealant on the engine front cover split lines. Refer to Adhesives, Fluids, Lubricants, and Sealers
for recommended sealant.
|
| 2 |
Camshaft Cover Seal Right Side
NOTE:
Install a NEW seal.
|
| 3 |
Camshaft Cover Right Side |
| 4 |
Camshaft Cover Bolt
Tighten in sequence
15 N.m (11 lb ft) |
| 5 |
Spark Plug
Tighten
18 N.m (13 lb ft) |
| 6 |
Ignition Coil Procedure
- Inspect the inside of the ignition coil rubber boot for a thin, even coat of grease. If there is no grease present or additional grease is necessary, complete the following procedure:
- Apply a thin coating of dielectric grease evenly to the inside of the ignition coil rubber boot, up to a depth of 15 mm from the end of the boot. Refer to Adhesives, Fluids, Lubricants, and Sealers
.
- Remove any excess grease from around the end of the boot, and ensure there is not an excessive amount within the boot.
|
| 7 |
Ignition Coil Bolt
Tighten
10 N.m (89 lb in) |