Ignition Coil, Spark Plug, Camshaft Cover, and Seal Installation

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Ignition Coil, Spark Plug, Camshaft Cover, and Seal

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Sealant Procedure Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant Place a bead 8 mm (0.3150 in) in diameter by 4 mm (0.1575 in) in height of RTV sealant on the engine front cover split lines. Refer to Adhesives, Fluids, Lubricants, and Sealers for recommended sealant.
2	Camshaft Cover SealLeft Side NOTE: Install a NEW seal.
3	Camshaft Cover Left Side
4	Camshaft Cover Bolt (Qty: 18) CAUTION: Refer to Fastener Caution . Tighten in sequence 15 N.m (11 lb ft)
5	Spark Plug (Qty: 3) NOTE: Install the NEW spark plugs. Tighten 18 N.m (13 lb ft)
6	Ignition Coil (Qty: 3) Procedure Inspect the inside of the ignition coil rubber boot for a thin, even coat of grease. If there is no grease present or additional grease is necessary, complete the following procedure: Apply a thin coating of dielectric grease evenly to the inside of the ignition coil rubber boot, up to a depth of 15 mm from the end of the boot. Refer to Adhesives, Fluids, Lubricants, and Sealers . Remove any excess grease from around the end of the boot, and ensure there is not an excessive amount within the boot.
7	Ignition Coil Bolt (Qty: 3) Tighten 10 N.m (89 lb in)