LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 417 (Engine Mechanical - 3.6L (LGX) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Intake Manifold Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Intake Manifold Cover And Fastener
    GM4289145Courtesy of GENERAL MOTORS COMPANY
  1. Install Intake Manifold Cover (2)
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install Intake Manifold Cover Fastener (1)
  3. Install Intake Manifold Cover Fastener (1) Tighten 10 N.m (89 lb in)
    4. Fig 2: Vacuum Hose
    GM4289486Courtesy of GENERAL MOTORS COMPANY
  4. Connect Vacuum Hose (1) @Intake Manifold Cover
    5. Fig 3: Vacuum Hose And Harness Connector
    GM4288978Courtesy of GENERAL MOTORS COMPANY
  5. Connect Vacuum Hose (2) - Plastic Collar Quick Connect Fitting Service
  6. Attqch the wire harness to the intake manifold cover as necessary.
  7. Connect Harness Connector (1)
  8. Manifold Absolute Pressure Sensor - Manifold Absolute Pressure Sensor Replacement
  9. Install Air Cleaner Outlet Duct - Air Cleaner Outlet Duct Replacement
scientia non olet · About LEMON Manuals