Installation Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Assemble the cylinder head as necessary. Cylinder Head Assemble
- Ensure the cylinder head locating pins (5) are securely mounted in the cylinder block deck face.
- Install a NEW left cylinder head gasket (4) using the deck face locating pins for retention.
- Install Cylinder Head Assembly (3) - Cylinder Head Installation - Right Side
- Camshaft Carrier- Right Side (2) - Camshaft Carrier Installation - Right Side
- Camshaft- Right Side (2) @Bank 2 - Camshaft Replacement - Right Side
- Position wire harness and connect as necessary.
- Install ground wire and ground wire bolt at the rear of the cylinder head. Tighten bolt to 15 N.m (11 lb ft).
- Install Fuel Pump (2) - Fuel Pump Replacement
- Install Warm Up Three-Way Catalytic Converter (2) @Bank 1- Warm Up Three-Way Catalytic Converter Replacement (Bank 1, LGX)Warm Up Three-Way Catalytic Converter Replacement (Bank 2, LGX)
- Install Fuel Injection Fuel Rail Noise Shield (1) - Fuel Injection Fuel Rail Noise Shield Replacement
- Install Camshaft Timing Chain- Right Side - Camshaft Timing Chain Assembly Replacement - Right Side
CAUTION:
Refer to Fastener Caution .