LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 417 (Engine Mechanical - 3.6L (LGX) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Camshaft Cover Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove Camshaft Housing Cover Insulator - Left Side. Camshaft Housing Cover Insulator Replacement - Left Side 
  2. Disconnect Positive Crankcase Ventilation Tube @Camshaft Cover
  3. Remove Ignition Coil - Bank 2. Ignition Coil Replacement - Bank 2
  4. Remove Camshaft Position Actuator Solenoid Valve Solenoid - Bank 2. Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Exhaust
  5. Remove Camshaft Position Actuator Solenoid Valve Solenoid - Bank 2 Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake
  6. Disconnect and remove the engine harness from the camshaft cover.
    7. Fig 1: Camshaft Cover, Bolt, Seal
    GM4122254Courtesy of GENERAL MOTORS COMPANY
  7. Remove Camshaft Cover Bolt (1)
  8. Remove Camshaft Cover (2)
  9. Remove Camshaft Cover Seal (3) and DISCARD
  10. Disassemble the camshaft cover as needed. Camshaft Cover Disassemble
  11. Clean the mating surfaces of the cylinder head and the camshaft cover. Camshaft Cover Cleaning and Inspection
scientia non olet · About LEMON Manuals