Removal Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Prior to removing the mount, mark the mount fasteners to mount and mount to sub frame interfaces using spray paint or a marker for correct positioning during installation.
- Using a suitable jack stand, support the rear of the powertrain.
- Remove the transmission mount to bracket through bolt (1).
- Lower the rear of the drivetrain and front suspension cradle enough the remove the rear mount bolts. Refer to Drivetrain and Front Suspension Cradle Removal and Installation (FWD)
- Remove and DISCARD the rear mount to drivetrain and front suspension cradle bolts (2).
- Remove the transmission rear mount
Fig 1: Transmission Mount To Bracket Through Bolt And Rear Mount To Drivetrain And Front Suspension Cradle Bolts
NOTE:
The nuts are reusable.