Installation Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Install the transmission range selector lever cable to the vehicle.
- Install the transmission range selector lever cable grommet (2) to the cowl panel.
- Install the grommet fasteners (1) and tighten to 9 N.m (80 lb in).
- Install the transmission range selector lever cable to the transmission control lever base. Insure the cable retainer (1) is fully secured to the transmission control lever base.
- Connect the transmission range selector lever cable terminal (2) to the shift lever pin.
- Install the left front floor console extension panel. Refer to Front Floor Console Extension Panel Replacement - Left Side
- Install the transmission range selector lever cable (2) to the cable bracket.
- Connect the transmission range selector lever cable terminal (1) to the transmission manual shift lever pin.
- Adjust the automatic transmission range selector lever cable. Refer to Range Selector Lever Cable Adjustment .
- Install the battery tray. Refer to Battery Tray Replacement
CAUTION:
Refer to Fastener Caution .
WARNING:
After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.