Front Cradle Mount Bolt Bracket Replacement (Rear)

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Cradle Mount Bolt Bracket

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Lifting and Jacking the Vehicle Support the front cradle with a suitable jack.
1	Drivetrain and Front Suspension Cradle Rear Bolt CAUTION: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. NOTE: Replace with a NEW bolt. Tighten First Pass: 160N.m (118 lb ft) Final Pass: (60-75 degrees)
2	Front Cradle Mount Bolt Bracket Bolt (Qty: 2) CAUTION: Refer to Fastener Caution Tighten 58 N.m (43 lb ft)
3	Front Cradle Mount Bolt Bracket