LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 408 (Automatic Transmission - 6T70 (M7U M7W) - Specifications) >> Specifications >> Fastener Specifications (On Vehicle)

Fastener Specifications (On Vehicle)

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 

Application
Control Valve Body Cover Wiring Connector Hole Seal
Front Wheel Drive Shaft Seal-Left
Front Wheel Drive Shaft Seal-Right
Input Speed Sensor Assembly Seals
Manual Shift Shaft Pin
Park Pawl Actuator Guide Assembly Seal
Park Pawl Actuator Guide Pin
Single Use Threaded Fastener/Component Tightening SpecificationsFastener

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 

Application Specification
Metric (English)
Left Transmission Mount to Transmission Bolt
  • First Pass:
50 N.m (37 lb ft)
  • Final Pass:
90- 105 Degrees
Rear Transmission Mount
  • First Pass:
100 N.m (74 lb ft)
  • Final Pass:
60- 75 Degrees
Rear Transmission Mount Bracket to Transmission Bolts (All Wheel Drive)
  • First Pass:
100 N.m (74 lb ft)
  • Final Pass:
45 - 60 Degrees
Rear Transmission Mount Bracket to Transmission Bolts (Front Wheel Drive)
  • First Pass:
100 N.m (74 lb ft)
  • Final Pass:
40 - 60 Degrees
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal 

Application Specification
Metric (English)
Control Valve Body to Case Bolt 11 N.m (97 lb in)
Control Valve Body Cover Bolt 11 N.m (97 lb in)
Drain Plug 12 N.m (106 lb in)
Fluid Level Hole Plug 12 N.m (106 lb in)
Fluid Pressure Test Hole Plug 12 N.m (106 lb in)
Front Transmission Mount Through Bolt 100 N.m (74 lb ft)
Front Transmission Mount to Transmission Bolt 58 N.m (43 lb ft)
Input Speed Sensor Bolt 9 N.m (80 lb in)
Left Transmission Mount to Body Bolts 58 N.m (43 lb ft)
Left Transmission Mount Bracket Bolts 22 N.m (16 lb ft)
Left Transmission Mount to Transmission Bolts 100 N.m (74 lb ft)
Manual Shift Detent Spring 12 N.m (106 lb in)
Output Speed Sensor Bolt 9 N.m (80 lb in)
Rear Transmission Mount to Bracket Through Bolt 100 N.m (74 lb ft)
Torque Converter to Flywheel Bolts 62 N.m (46 lb ft)
Transmission to Engine Bolts 58 N.m (43 lb ft)
Transmission Range Selector Cable Bracket 25 N.m (18 lb ft)