Installation Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Parking Brake Actuator»Install — Parking Brake Actuator Replacement
- Align the right edge in the upper notch of the left rear brake caliper piston (1) with the left edge of the caliper logo as shown.
- Align the left edge in the upper notch of the right rear brake caliper piston (1) with the right edge of the caliper logo as shown.
- Install Brake Caliper (1)
- Install Brake Caliper Guide Pin Bolt (1) and tighten 40 N.m (30 lb ft)
- Install NEW Brake Hose Fitting Gasket (1) @ Brake Hose Fitting (2)
- Install Brake Hose Fitting Bolt (1) and tighten 44 N.m (32 lb ft)
- Connect the parking brake actuator electrical connector.
- Using an appropriate tie strap, secure the parking brake actuator electrical harness to the harness bracket.
- Bleed the brake system. Hydraulic Brake System Bleeding (Manual)Hydraulic Brake System Bleeding (Pressure)
- Install the tire and wheel assembly. Tire and Wheel Removal and Installation
Fig 1: Aligning Right Edge In Upper Notch Of Right Rear Brake Caliper Piston With Left Edge Of Caliper Logo
Fig 2: Aligning Left Edge In Upper Notch Of Right Rear Brake Caliper Piston With Right Edge Of Caliper Logo
CAUTION:
NOTE:
Install NEW brake hose fitting gaskets.