Removal Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
WARNING:
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the tire and wheel assembly. Tire and Wheel Removal and Installation
- Remove Brake Hose Fitting Bolt (1)
- Remove Brake Hose Fitting Gasket (1) @ Brake Hose Fitting (2) and DISCARD
- Cap the brake hose fitting to prevent brake fluid loss and contamination.
- Remove Brake Caliper Guide Pin Bolt (1)
- Remove Brake Caliper (1)
NOTE:
Do NOT reuse the brake hose fitting gaskets.
NOTE:
Do NOT use any air tools to remove or install the guide pin bolts. Use hand tools ONLY.