Installation Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Install the NEW wheel stud (1) into the wheel bearing hub flange (2).
- Add enough washers (3) in order to draw the stud into the hub flange (2).
- Install the wheel nut (4) against the washers (3).
- Tighten the wheel nut (4) until the head of the wheel stud (1) is fully seated against the back of the bearing hub flange (2).
- Remove the wheel nut (4) and the washers (3).
- Remove the wheel bearing and hub assembly from the vise.
- Install Rear Wheel Bearing and Hub Assembly.Rear Wheel Bearing and Hub Replacement (AWD) Rear Wheel Bearing and Hub Replacement (FWD)
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation .