Installation Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Install Rear Suspension Upper Trailing Link (1)
- Install NEW Rear Suspension Upper Trailing Link Inner Bolt (2).
- Install Rear Suspension Upper Trailing Link Inner Nut (1)
Tighten the Bolt
- First Pass: 100 N.m (74 lb ft)
- Final Pass: (90-105 degrees)
- Install NEW Rear Suspension Upper Trailing Link Outer bolt (1) and washer (2).
Tighten
- First Pass: 100 N.m (74 lb ft)
- Final Pass: (90-105 degrees)
- Raise the rear suspension cradle to its original position. Rear Suspension Cradle Replacement (AWD)Rear Suspension Cradle Replacement (FWD)
CAUTION:
Refer to Fastener Caution .
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.