Installation Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Position the front stabilizer shaft (2) on the drivetrain and front suspension cradle.
- Install and tighten Front Stabilizer Shaft Insulator Clamp Bolts (1) (Qty: 4) to:
Install NEW bolts.
Tighten
- First Pass: 22 N.m (16 lb ft)
- Final Pass: (90-105 degrees)
- Install Drivetrain and Front Suspension Cradle (1). Refer to Drivetrain and Front Suspension Cradle Replacement (AWD)Drivetrain and Front Suspension Cradle Replacement (FWD)
- Measure and adjust the wheel alignment. Refer to Wheel Alignment Measurement
CAUTION:
Refer to Fastener Caution .
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.