Installation Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- Install Instrument Panel Knee Bolster (1)
- Connect all electrical connectors.
- Install and tighten Instrument Panel Knee Bolster Bolts (3) (Qty: 8) to 2.5 N.m (22 lb in)
- Connect the data link connector (2).
- Install Hood Primary Latch Release Cable Handle (1).
- Install Front Floor Console Trim Plate (1). Refer to Front Floor Console Trim Plate Replacement
- Install Instrument Panel Outer Trim Cover - Left (1). Refer to Instrument Panel Outer Trim Cover Replacement
- Install Instrument Panel Lower Airbag - Driver Side. Refer to Instrument Panel Lower Airbag Replacement - Driver Side
- Install Instrument Panel Insulator (2). Refer to Instrument Panel Insulator Replacement - Left Side
Fig 2: Hood Primary Latch Release Cable Handle, Data Link Connector And Instrument Panel Knee Bolster Bolts
CAUTION:
Refer to Fastener Caution .